Zapco STUDIO 500 Manual de usuario

The Studio X Mono Class D Amps There are three Class D mono amps in the Studio X line,. The ST-500X at 500 was RMS, the ST-1000XM at 1,000 was and t

The ST-1000XM and ST-1500XM Input side The larger Studio X bass amps have all the features of the ST-500XM but they also add more bass co

1. GND The amp should have a rm connecon the car frame. * See sec-on "Install Sense" 2. REM The remote terminal connects to the head u

Strapping Studio X Mono Amps Studio X mono amps are true mono units and you can double their power by “strapping” two units of the same model together

Strapping the Outputs of the Studio X Mono Amps + - Master amp Slave amp 2Ω Minimum Load As Above 1. Connect the master amplier’s speaker output +

Speaker Connecons ST-2X Standard stereo hook-up connects + and-leads from the correct terminal to each speaker, taking care that no wire or speaker t

ST-4X 4Ω Min Load 2Ω Min Load 2Ω Min Load Like the ST-2X, the ST-4X will drive 4Ω or 2Ω loads and can be hooked in 3 channel mixed mono mode. Althoug

4Ω Min Load 4Ω Min Load You can create a high power stereo amp by us-ing the ST-4X in Dual Mono mode where the front amp powers one channel and the re

Specicaons ST-2X 170 Was RMS Max RMS at 2Ohms @ <.5% THD at 1KHz 2 x 85 was / 1 x 170 was *Rated RMS Power 50w x 2 @

ST-500XM 500 Was RMS Rated RMS Power 150w x 1 @ 4Ω / 250w x 1 2Ω / 500w @ 1Ω THD + Noise < 0

Zapco has a reputaon for sound reproducon and quality that is unsurpassed. It is our dedicaon to sonic purity and our passion for performance

Install Sense As a manufacturer, Zapco has taken great pains to produce a product that will give you many years of superior performance and reliabili

The ST-2X Two channel, compact chassis car amplier with RCA pre-amp input and speaker level input ST-2X Input 1 2 3 8 6 5 4 7 1. RCA IN connecto

ST-2X Output 3 6 5 4 2 1 1. LED Indicators let you know the status of the amplier. The green LED tells you the amp is on. The Red

The ST-4X Four channel, compact chassis car amplier with RCA pre-amp input and speaker level input 2 1 3 7 11 8 4 9 5 10 12 6 1. Rear Crossover se

9. Front Gain: This control balances output of the head unit to the input of the amp and with the rear amp channels 10. Rear Outputs: These provide

tells you the amp is on. The Red LED lets you know the amp is in “protecon” because of some problem with the system. 6. Fuses The f

pass crossover. 7. Crossover switch chooses low pass or full range for the sub output 8. Bass Boost allows 6dB or 12dB boost of bass frequencies in